Εγχειρίδιο Honeywell HT-109E Ανεμιστήρας

Εγχειρίδιο

4

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

1. Please read all instructions before using this fan.

2. Only use this fan as described in this manual. Other non-

recommended use may cause fire, electric shock, or injury.

3. Only connect the fan to a single-phase power socket with the

current as stated on its type plate.

4. Connect power after the fan has been fully assembled. Unplug

from outlet when moving fan from one location to another,

before putting on or taking off parts and before cleaning.

Disconnect the fan when not in use. Do not tug at the power cord

to disconnect the plug.

5. Supervision is needed when the fan is used anywhere near

children. This appliance is not intended for use by children or

other persons without assistance or supervision if their physical,

sensory or mental capabilities prevent them from using it safely.

6. If the supply cord is damaged, it must be replaced by the

manufacturer or its service agent or a similarly qualified person in

order to avoid a hazard.

7. Unwind the power cord completely. An incompletely unwound

power cord can lead to overheating and cause a fire. Do not touch

the power cord with wet hands. Position the power cord so that

nobody can trip over it and where the socket can be reached

easily.

8. Do not use an infinitely variable speed controller. This can lead

to overheating, fire, electric shock or faults in the appliance.

9. Do not operate the fan without the protective front and rear

grilles in position. Do not touch the rotating fan blades with any

part of the body. This can cause personal injury and damage.

10. Never insert fingers, pencils, or any other object through the

grille when fan is running.

11. Do not operate the fan if it is damaged or might be defective,

or if it is not working properly. Remove the power plug from the

socket.

12. Do not use the fan anywhere near easily inflammable gases or

substances such as solvents, lacquers, glues etc.

13. The fan is only designed for private use in indoor rooms and

is not intended for outdoor or for commercial use. Do not use the

fan anywhere near a bathtub, a shower or a swimming pool, or

anywhere else where water could splash.

14. Do not plunge the fan into water or any other liquids and do

not pour water or any other liquids over the fan.

15. Place the fan on a firm, even, dry surface. Be sure the fan is on

a stable surface when operating to avoid overturning. Make sure

the fan is standing securely so that it cannot tip over or fall down.

Maintain a safety distance of at least 50 cm from other objects.

16. Clean the fan regularly by following the cleaning instructions.

COMPONENTS

1. Front Grille

2. Spinner

3. Blades

4. Plastic Nut

5. Rear Grille

6. Motor Shaft

7. Speed Knob

8. Oscillating Clutch Knob

9. Motor Housing

10. Tilt Adjustment Knob

11. Power Supply Cord with Plug

12. Base

ASSEMBLY INSTRUCTIONS

Assembly of Blade and Guards

1. Unscrew the spinner clockwise and the nut counter-clockwise

to separate them (Steps 1, 2, and 3 - Fig. 1).

2. Set the rear guard in the proper position with

handle up.

3. Screw on plastic nut tightly to attach rear grille.

4. Discard plastic sleeve on motor shaft. Install the blade onto the

shaft until it reaches the retaining pin (Steps 4, and 5 - Fig. 2).

5. Screw spinner onto motor shaft counter clockwise to blade.

6. Press the front grille onto the rear grille until the front grille is

properly fitted, fix both grilles with rim and use a screw driver to

tighten the locking screw.

7. Secure both grilles firmly by tightening the fan grille locking

screws and nuts (Fig. 3).

OPERATING INSTRUCTIONS

Speed Knob

The speed of the fan is controlled by rotating the speed knob.

The number on the knob will indicate which of the two speeds is

in effect:

0 = Off; 1 = Low; 2 = High.

Oscillation

To make the fan oscillate, press down on the oscillating control

knob located on the top of the motor housing. To stop oscillation,

pull up on the knob.

Tilt Adjusting

To adjust the airflow upward or downward, loosen the screw,

gently push the grilles (1,5) to the desired position and retighten

the screw.

HT-109E_OM.indd 4 1/9/07 4:44:31 PM

Βαθμολογία

Περισσότερα για αυτό το εγχειρίδιο

Κατανοούμε ότι είναι ωραίο να έχετε ένα χάρτινο εγχειρίδιο για το Honeywell HT-109E Ανεμιστήρας σας. Μπορείτε πάντα να κατεβάσετε το εγχειρίδιο από τον ιστότοπό μας και να το εκτυπώσετε μόνοι σας. Εάν θέλετε να έχετε ένα πρωτότυπο εγχειρίδιο, σας συνιστούμε να επικοινωνήσετε με το Honeywell. Μπορεί να είναι σε θέση να παρέχουν ένα πρωτότυπο εγχειρίδιο. Αναζητάτε το εγχειρίδιο του Honeywell HT-109E Ανεμιστήρας σας σε διαφορετική γλώσσα; Επιλέξτε τη γλώσσα που προτιμάτε στην αρχική μας σελίδα και αναζητήστε τον αριθμό μοντέλου για να δείτε αν τον έχουμε διαθέσιμο.

Προδιαγραφές

Όλα τα εγχειρίδια για Honeywell Ανεμιστήρες
Περισσότερα εγχειρίδια του Ανεμιστήρες

Συχνές ερωτήσεις σχετικά με Honeywell HT-109E Ανεμιστήρας

Η ομάδα υποστήριξής μας αναζητά χρήσιμες πληροφορίες προϊόντος και απαντήσεις σε συχνές ερωτήσεις. Εάν εντοπίσετε ανακρίβεια στις συνήθεις ερωτήσεις μας, ενημερώστε μας χρησιμοποιώντας τη φόρμα επικοινωνίας.

Σχετικά προϊόντα

Εγχειρίδιο

Honeywell HO-5500RE Ανεμιστήρας

Εγχειρίδιο

Honeywell HT-700WBE Ανεμιστήρας

Εγχειρίδιο

Honeywell ES-800 Ανεμιστήρας

Εγχειρίδιο

Honeywell HY254E Ανεμιστήρας

Εγχειρίδιο

Honeywell HT-112E Ανεμιστήρας

Εγχειρίδιο

Honeywell HT-700PE Ανεμιστήρας

Εγχειρίδιο

Honeywell HT-116E Ανεμιστήρας

Εγχειρίδιο

Honeywell HT-900E Ανεμιστήρας

Σχετικές κατηγορίες